Welded Fork Head Steel Castings
The bottom of the fork head is welded in the form of spline shaft spline sleeve and can also be welded nozzle. Can adjust the center high production according to customer requirements.
Send Inquiry
Product Description
The bottom of the fork head is welded in the form of spline shaft spline sleeve and can also be welded nozzle. Can adjust the center high production according to customer requirements.
1. Porosity sand hole and other defects as low as 0.1%, disappear mold process, single product casting method to reduce product defects.
2. The chemical composition is stable up to standard (the company is equipped with pre-furnace testing equipment to test each furnace molten steel to ensure that the product is cast after reaching the standard).
3. Batch sampling before delivery, spectrometer report, double detection is safer.
4. Small margin (2mm-5mm) years of casting experience, master casting cooling steps.
FAQ
Q:How do you pack the equipment?
A:We load the goods in wooden cases.
Q:Can you can design the equipment according to our size?
A:Yes.
Q:Do you provide sample? Free or charge?
A:We can provide samples free of charge.
Q:How many production lines in your factory?
A:Two, can simultaneously produce 10 rolling wire equipment.
Q:How many staff abroad you sent to install the equipment?
A:According to site requirements.
Q:You have sales target finished amount requirement to the distributor?
A:No requirement.
Q:How many years have your company made this kind of equipment?
A:More than 10 years.
Q:How many staffs do you have in your factory?
A:More than 80 staffs.
